Milwaukee 48-22-8547 Manuel De L'utilisateur page 5

2. Attach the two brackets to the back of the product
to secure the top chest to the rolling cabinet. Place
the brackets over the holes and secure with four
screws (DD) per bracket.
3. Tighten all screws securely with a Phillips screw-
driver.
DD
Installing the Drawer Liners and Mat
Place the drawer liners in appropriately sized draw-
ers and the mat in the chest lid area to protect the
surface.
Installing the Corner Extrusions
and Bumpers
Place the front bumpers on both ends of the extrusion
by sliding the extrusion into the cavity of the bumpers.
Attach the front bumpers with extrusions to the chest
and cabinet using two screws (EE) per bumper.
Attach the two rear bumpers to the back of the lower
cabinet using two screws (EE) per bumper.
Installing the Cord Storage Brackets
Attach the brackets to the back of the chest and
cabinet with two screws (DD) per bracket. Orient the
brackets with one pointed up and one pointed down
so that the power outlet cord can be wrapped around
the brackets for storage.
Installing the Power Cord
Locate the power cord inside one of the right-hand
drawers. Untie the power cord and gently pull the
cord plug through the grommet.
WARNING
pacity. Use care when moving chest/cabinet on
incline or rough surface. Chest/cabinet may tip
if weight is not evenly distributed front to back
and side to side. Place more than half the total
load weight on the bottom cabinet when possible.
Locking and Unlocking the Chest/Cabinet
NOTE: The drawers must be fully closed before
locking/unlocking the unit.
Insert the key. Turn it fully left to lock, or fully right to un-
lock. Always remove the key after locking and unlocking.
Using the Caster Brakes
To lock the swivel casters,
step down on the levers
marked ON. Be sure to lock
both casters to prevent
chest/cabinet from rolling or
swiveling. To unlock casters,
push down on the levers-
marked OFF.
Moving the Chest/Cabinet on an Incline
Take care that the chest/cabinet does not tip or
become unbalanced when moving it on an incline
or rough surface. Do not exceed an incline of 10
degrees. Lock the chest/cabinet and secure all items
before moving.
Rolling the Chest/Cabinet
The chest/cabinet is only intended for rolling short
distances. Only roll the chest/cabinet using the han-
dle. Do not push or pull chest/cabinet by the frame
or product may tip. Do not modify the chest/cabinet
in any way. Drilling holes or modifying the chest/
cabinet will lower the load capacity, which can cause
the chest/cabinet to collapse, resulting in injury. Lock
the chest/cabinet and secure all items before rolling.
Lifting the Chest/Cabinet
The cabinet and chest/cabinet combo are not in-
tended to be lifted. However, if you need to lift, empty
the chest/cabinet and then place straps or forks
inside and next to casters. Do not lift loaded chests/
cabinets. Never lift by the side handle. Be sure all by-
standers are moved away before lifting chest/cabinet.
The rolling cabinet comes equipped with four pre-
installed charger mounting bosses, located below the
power strip. The charger mounts are suitable for hold-
ing MILWAUKEE M18™ & M12™ Multi Voltage char-
gers as well as M18™ chargers. To mount a charger,
EE
install a screw (DD) into each boss, then slide the
charger's key-hole slots over the screws. Slide the
charger toward the floor to lock it onto the screws.
5
OPERATION
To avoid injury or property damage,
do not exceed maximum shelf ca-
or Rough Surface
Mounting Chargers