Clamping The Workpieces; Removing Blockages; Cleaning And Maintenance; Cleaning - Parkside PTBM 400 A1 Traduction Des Instructions D'origine

Clamping the Workpieces

Only work on workpieces that can be secu-
rely clamped between the chuck jaws (14).
The workpiece must not yield too much.
Otherwise it is nor possible to apply ade-
quate tension.
The workpiece must not be too small or too
large either.

Removing Blockages

- You should always select a suitable
feed rate which allows trouble-free chip
breaking.
- If the bit is jammed in the workpiece,
turn off the power and unplug the po-
wer cord. Turn the bit on the drill chuck
anticlockwise with a little jerk to break
the chip and release the bit again.
- If a fragment is produced during the
processing of the workpiece, turn off the
power and unplug the power cord. Use a
pair of pliers and remove the fragment to
prevent it flying off in an uncontrolled way.
Cleaning and

maintenance

Pull the mains plug before any ad-
justments, maintenance or repair.
Have any work on the device
that is not described in this in-
struction guide performed by
a professional. Only use ori-
ginal parts. Allow the device
to cool off before any mainte-
nance or cleaning is underta-
ken. There is a risk of burning!
Always check the device before using it
for obvious defects such as loose, worn or
damaged parts, correct the positioning of
screws or other parts. Exchange the dama-
ged parts.

Cleaning

Do not use any cleaning agents or
solvents. Chemical substances can
etch the plastic parts of the device.
Never clean the device under run-
ning water.
• Thoroughly clean the device after every
use.
• Clean the ventilation openings and the
surface of the device with a soft brush
or cloth.
• Remove chips, dust and dirt with a va-
cuum cleaner if necessary.
• Lubricate moving parts regularly.
• Do not allow lubricants to come into
contact with switches, V-belts, pulleys
and drill lifting arms.
Maintenance
The device is maintenance free.
GB IE
33