Philips Azur Freemotion Mode D'emploi page 11

Problem
Flakes and
impurities come
out of the soleplate
during ironing.
Only part of
the light ring is
lighted in safety
auto-off mode.
The base is not
lighted up when
I place the iron
on it.
Possible cause
You have not
performed Calc-Clean
function for some time.
The iron need to be
cleaned.
This is normal. This
is intended to save
energy in safety auto-
off mode.
The iron is not
connected to the base
properly.
ENGLISH
Solution
Use the Calc-Clean
function (see chapter
'Cleaning and
maintenance', section
'Calc-Clean function').
N/A
Take out the iron and
put it back to the base
again.
13