Klein Tools VDV500-051 Manuel D'instructions page 2

ENGLISH
TONEcube & PROBEplus
The Klein Tools TONEcube is a professional series tone generator for wire
tracing. It features several tone frequencies and strong power output to
assist in tracing wire.
• Five different tone sounds selectable by tone switch.
• Constant output level over useful battery life.
• Tone auto-off after 1.5 hours.
• No battery drain in continuity mode with leads open.
• Separate status LEDs for normal and reverse line polarity.
• Tone operates in either continuity or status modes.
• Modular plug for direct connection to phone jacks.
• Alligator clips for wire connection.
• Sliding momentary tone switch prevents accidental activation.
• Battery low indication.
• Lanyard attachment loop.
TONEcube GENERAL SPECIFICATIONS
•
Dimensions:
7.0 oz. (200 grams) with battery
•
Weight:
•
Operating Temperature:
•
Storage Temperature:
• 10% to 90%, non-condensing
Humidity:
• 10,000 feet (3,000 meters) maximum
Altitude:
• Life: 9V alkaline battery - typical
Battery
• Standby:
• Active:
• Tone Sounds:
• Continuity Indication:
• Voltage Protection:
• Status Mode:
• Continiuity Mode:
• Power: 8dBm (into 600Ω until battery low)
Tone
The Klein Tools PROBEplus is a professional series tone tracer for wire
tracing and cable identification. It features digital volume control and a loud
built-in speaker to assist you in tracing and identifying wire.
• Tap power button to toggle on/off: continuously holding down the
power button is optional.
• Hold on/off button to power on; release to power off.
• Digital volume control.
• Tone detection LED.
• Amplifier overload LED.
• Battery Low Indication.
• External tip replacement.
• Lanyard attachment loop.
2
Instruction Manual
TONEcube FEATURES
2.75" x 2.5" x 1.42" (6.99 x 6.35 x 3.61 cm)
0°C / 32°F to 50°C / 122°F
-20°C / -4°F to 60°C / 140°F
4 years
120 hours
high-warble, low-warble, mono, ascending, descending
less than 10kΩ
60 Volts
20 Volts through external 600Ω
PROBEplus FEATURES