Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
ENGLISH
1
4
• LEDs
1. Tone LED:
rapidly when battery is low. Toggles one second on and one second
off when tone cadence is changing.
2. NRM (Normal):
with normal polarity of a phone line in status mode. Both LEDs are
on if AC voltage.
3. REV (Reverse):
reverse polarity of a phone line in status mode. REV lights with low
resistance across clips in continuity mode. Both LEDs are on if AC
Voltage.
• Switches
4. TONE:
This switch is a momentary slide switch. When slid to the
left for a short duration, it toggles between tone on and off. If held
on, it begins to send different tone sounds in sequence until the
switch is released, setting the tone style.
5. CONT-STAT:
and REV) to indicate voltage and polarity, the STATUS position, or
continuity on the REV LED, the CONT position. When the TONEcube
is not in use the switch should be left in the STAT position to prevent
draining the battery.
CAUTION:
toning live wires. This may cause damage to the TONEcube.
4
TONEcube FRONT PANEL
Flashes once per second when tone is on. Flashes
Green LED is on when a DC voltage is present
Red LED is on when DC voltage is present with
This slide switch configures the status LEDs (NRM
Continuity (CONT) mode should NOT be used when
2
3
5
Publicité
Table des Matières
