Publicité
Les langues disponibles
Les langues disponibles
6.1.2 Battery
Control the charge level of the battery regularly by reading the battery display in the digital instrument. If only one charging bar is visible re-charge the battery.
In the event of longer periods of non-use, e.g. winter break, charge the battery every three months. When starting to use the FIXbike after a long break, connect
the battery to the charging device for approx. one day.
6.1.3 Chain
Lubricate the chain every 500 km or after each cleaning and after every ride in the rain with a chain lubricant from a specialised bike shop. Check the chain
tension every 500 km. To do this, lift the returning part of the chain in the middle. If the chain can be lifted more than the height of five chain links, the chain
tension is too low and the chain must be tightened or replaced.
6.1.4 Brakes
If the performance of the brakes decreases and you have to pull the brake handle very far, readjust the brake cables by untwisting the adjusting screw on the
brake lever. When this is no longer enough to guarantee safe braking performance, find a specialised bike workshop to repair the brakes.
6.1.5 Changing remote control batteries
Two button batteries, Type CR2025, 3V, lithium, are needed for replacement. Open the remote control and switch the batteries as depicted in Images 25 to 28.
When inserting the battery ensure that the positive terminal of the button batteries is on top.
Image 25: Remove
casing screws
Assembly is performed in reverse sequence.
6.2 Inspection and service plan
Runtime in km
Electr. system, lighting
Tyre pressure, tread depth at least 1 mm
Suspension fork, shock absorption / impermeability
Battery charging voltage
Check battery for impermeability
Check brake cables for damage
Brake disk, brake pad front
Brake disk, brake pad back
Bell
Check main motor cable for damage
Pedal / bearing play
Check that the electric motor is centrally mounted
Tightness of all screws relevant for safety
Brake light switch
Headlight settings
Wheels: Bearing play, smooth operation
Check tyres for damage and foreign objects
Steering head bearing play, handlebar screws
Speedometer
Lubrication areas: Lines, levers, brake cams, side stands, locking
mechanisms, chain *)
C = Check, R = Replace
*) see Chapter 6.1.3
6.3 Care
Never clean the FIXbike with a high-pressure cleaner. This can damage the tyres and destroy seals. Water can permeate the bearings and the electric
system.
Use conventional cleaning and care products for bikes when cleaning. Prevent penetration of liquid into the interior of the electrical system and into the digital
instrument. Do not use a polishing product for the plastic surfaces.
18
14500_ML-EAL-2017.indd 18
Image 26: Carefully remove
circuit board from the casing
Inspection and service intervals
Image 27: Remove battery
holder
300
2000
4000
C
C
C
C
C
C
C
C
C
C
C
C
C
C
C
C
C
C
C
C
C
C
C
C
C
C
C
C
C
C
C
C
C
C
C
C/R
C
C
C
C
C
C
C
C
C
C
C
C
C
C
C
C
C
C
C
C
C
C
C
C
Image 28: Place batteries into the battery
holder
6000
C
C
C
C
C
C
C/R
C/R
C
C
C
C/R
C
C
C
C
C/R
C
C
C
13.10.17 10:56
Publicité
Chapitres
