Charging Unit; Battery; Operating Instructions; Assembly - EUFAB FIXbike e-Mobility 14500 Mode D'emploi

• Before each ride, ensure that the brakes function, the tire pressure is ok, and that all fixtures are in faultless condition.
• Ensure that accessory parts are mounted at the right positions and familiarise yourself with the functions.
• When using the FIXbike for the first time, first try it out on a short, safe section of road. Only drive in road traffic when you have good control riding the
FIXbike.
• A quick-release lever that isn't completely closed can re-open. This can lead to serious falls. Turning the quick-release lever must be so difficult that the
heel of the hand is required to do so. Only then is the tension strong enough.
• Always wear a helmet.
• Wear bright and noticeable clothing. Be sure not to wear loose clothing that could get stuck in the chain, handlebars, pedals or wheels.

4.2 Charging unit

• Do not use the charging unit in a moist or wet environment.
• Be sure to prevent water from penetrating the device. If liquid should get inside, immediately separate the charging unit from the power supply and
have it checked by an authorised dealer.
• Place the charging unit on an even surface only so that it stands firmly.
• Do not operate the charging unit with damaged cable or plug.
• Do not operate the charging unit after it has received a strong hit, has fallen or been damaged in any other way.
• Do not attempt to repair the device yourself. Do not open or disassemble the device. Have the charging unit checked by your authorised dealer.
• Before cleaning, separate the charging unit from the power supply and from the battery.

4.3 Battery

• The FIXbike's charging unit and battery are mutually compatible. Never charge the battery using a different charging unit.
• Protect the battery from moisture and hard impacts.
• Do not use the battery after it has received a strong hit, has fallen or been damaged in any other way.
• Do not attempt to repair the device yourself. Do not open or disassemble the casing of the battery. Have the battery checked by your authorised dealer.
• Do not touch the battery contacts with metal objects.
• Never leave the battery permanently connected to the charging device when not in use for a long period of time.
• Do not leave the battery unattended during the charging procedure.

5. Operating Instructions

5.1 Assembly

5.1.1 Handlebar assembly

The handlebars of the FIXbike are pre-assembled and just need to be attached to the
head tube. Do to so, loosen the screw (A) and remove the protective cap (C), see Image
1. Place the handlebars onto the head tube.
ATTENTION: The electrical cables and brake lines cannot be twisted, kinked
or clamped.
Straighten the handlebars and tighten both screws (B). Place the screw (A) back in the control head and tighten it.

5.1.2 Pedal assembly

The pedals are marked with the letter „R" for the right and „L" for the left side, see Image
2. The right pedal has a right-hand thread, the left one has a left-hand thread. Screw
the right pedal clockwise into the threaded hole of the right pedal crank. Screw the left
pedal counter-clockwise into the threaded hole of the left pedal crank.

5.1.3 Rear mudguard assembly

Place the mudguard on the frame of the back wheel. Align it with the mounting holes
and screw it tight with both screws, Image 3.
14500_ML-EAL-2017.indd 13
Image 1: Assembling the handlebars
Image 2: Labelling on the pedals
Image 3: Back mudguard
13
13.10.17 10:56