Handlebars; Digital Instrument; Remote Control; Charging Unit - EUFAB FIXbike e-Mobility 14500 Mode D'emploi

5.2.2 Handlebars

15 Brake handle, back wheel
16 Adjusting screw, back wheel brake
17 Adjusting screw, front wheel brake
18 Brake handle right, front wheel
19 Bell
20 Light switch
21

Digital instrument

5.2.3 Digital instrument
22 Speed display
23 Mileage
24 Battery display
25 Travel time
26 Outside temperature

5.2.4 Remote control

27 Control light
28 Anti-theft alarm on switch
29 Anti-theft alarm off switch
30 Vehicle search button
31 Start button
32 Eyelet for keyring

5.2.5 Charging unit

33 Power plug
34 Charging plug
35 Charging unit
36 Control light

5.2.6 Battery

37 Lock
38 Charging socket with protective cap
39 Rear light
40 Connections
41 Locking mechanism

5.3 Operation

5.3.1 Charging the battery

The battery can be charged in an installed and uninstalled state. Switch the FIXbike off (see Section 5.3.2) when charging the battery that is not installed.
Connecting the charging unit:
First remove the protective cap from the charging socket (Position 38 in the overview) on the left side of the battery. Plug the charging plug (Position 34 in the
overview) into the charging socket and tighten the plug's cap nut. Lastly, plug the power plug (Position 33 in the overview) of the charging unit into the socket.
The control light (Position 36 in the overview) of the charging unit lights up while the battery is charging. When the battery is full, the control light turns green.
Removing the charging unit:
First pull the power plug out of the socket. Then loosen the cap nut of the charging plug and pull it out of the battery's charging socket. Reattach the protective
cap. Always observe this sequence.
14500_ML-EAL-2017.indd 15
Image 10: Handlebars overview
Image 11: Digital instrument overview
Image 12: Remote control overview
Image 13: Charging unit overview
Image 14: Battery overview
15
13.10.17 10:56