Hendi 210048 Mode D'emploi page 12

Problem
Appliance does not slice well
Appliance stops slicing
Carriage does not slide
Sharpening the blade
Sharpen the blade when it becomes blunt.
The blade is extremely resistant to wear. If used regularly and properly, it should only need to be
sharpened once a year.
• Pull the plug from the wall socket.
• Turn the thickness dial to 0.
• Clean the blade.
• Unscrew the sharpener's locking knob.
• Lift the sharpener from the locking device and turn it 180°.
• Lower the sharpener until it slips back into the locking device.
• Fix the sharpener in place by tightening the locking knob.
• Switch on the appliance. The blade will start to turn.
• Use the button to press the tilted sharpening stone against the blade and keep it there for 2
minutes. The sharpening stone should turn along with the blade.
• Use the button to press the vertical sharpening stone briefly against the blade to remove burrs.
The sharpening stone should turn along with the blade.
• Switch off the appliance and pull the plug from the wall socket.
• Unscrew the sharpener's locking knob and clean the sharpening stones with alcohol.
• Replace the sharpener in its original position on the appliance and tighten the locking knob to fix
it in place. The blade must not extend between the sharpening stones.
• Clean the blade with alcohol. WARNING! The blade is extremely sharp.
• Push the plug in the wall socket.
• The appliance is ready for use.
Technical data
AC power supply
Power consumption
Blade diameter
Guarantee
Any defect, with the exception of normal wear and failure of the lights, affecting the functionality of
the appliance which becomes apparent within one year of its purchase will be corrected by free
repair or replacement provided that it has been used and maintained in accordance with the
instructions and has not been abused or misused in any way. Your statutory rights are not affected. If
it's under guarantee, state where and when it was bought, and include proof of purchase (e.g. bill
receipt). In line with our policy of continuous product development we reserve the right to change
product, packaging and documentation specifications without notice.
Discard
At the end of the life of the appliance, please cast of the appliance according to the regulations and
guidelines applying on that moment.
Possible cause
Blunt blade
Dirty appliance
Overheated motor
Dirty slide bar
When in doubt, always contact your supplier!
210048 Slicer 220mm
230~240 VAC/50 Hz
210 W
220 mm
Solution
Sharpen blade
Clean the appliance
Let the machine cool off for an extended period.
The motor's safety thermostat will reset itself
automatically.
Clean the slide bar and lubricate with Vaseline
12