Hendi 210048 Mode D'emploi page 11

Instructions for use
• Position the appliance so that the on/off switch is facing the user.
• If the blade sharpener has not been installed, proceed as follows:
o Position the blade sharpener in its support so that the blade does not extend between the
gears.
o Tighten the safety screw on the blade sharpener.
• Turn the appliance off (the appliance is equipped with a safety switch and will turn off
automatically if the sharpening device is removed)
• Push the plug in the wall socket.
• Turn the dial with the graduated scale to the desired slice thickness.
• Switch on the appliance using the on/off switch. The blade will start to turn.
• Put the food product on the carriage and adjust the clamp to hold the product firmly in place.
Make sure the product is positioned against the stop plate.
• Once the product has been sliced, switch off the appliance with the on/off switch. The blade will
stop turning.
• Turn the thickness dial back to 0.
Cleaning and maintenance
•
Turn the slice thickness dial in counterclockwise direction to the "0" position,
•
Always pull the plug from the socket before cleaning the appliance.
•
Warning: Never submerge the appliance in water or other liquids!
•
Use a damp cloth to clean surfaces (solution of water and a mild cleaning agent).
•
Never use corrosive or abrasive cleaning agents. Do not use sharp or pointed objects for
cleaning. Do not use benzene or solvents! Clean with a damp cloth. Use washing-up liquid if
needed, but never abrasive cleaning agents.
•
Clean the blade with alcohol. WARNING! The blade is extremely sharp.
• If the food carriage stops sliding smoothly, lay the machine on its side. Clean the slide bar
carefully and lubricate it with Vaseline
11