Hendi 210048 Mode D'emploi page 10

Preparations before using for the first time
•
Check to make sure no parts are missing. If any parts are missing, contact your supplier.
•
Remove all the packing material.
•
Clean the appliance with lukewarm water and a soft cloth.
•
Clean the blade. Be careful: the blade is very sharp.
• If the sharpening device is not attached, proceed as follows:
•
Attach the hand guard.
NOTE! You are advised not to use the appliance if the hand guard are not attached as
•
instructed! These are safety features that will prevent possible injury. If you do not attach these
features, there will be a risk of injury.
•
Keep open a space of at least 10 cm around the appliance to allow for adequate ventilation.
•
Position the appliance in such a way that the plug is always accessible.
1
Top view of the
appliance
2
Attach the
sharpening module
in such a way that
the blade does not
move between the
wheels.
1
Place both screws in
the carriage.
2
Attach the hand
guard.
NOTE! The sharpening device is equipped
with a safety switch. If the sharpening device
is not properly attached, you will not be able
to use the appliance.
3
Secure the sharpening
device to the machine
by tightening the holder.
Check to make sure that
the sharpening device is
well secured before
using the machine.
3
Place the two washers
over the bolts.
4
Screw on the two dome
nuts.
10