Integrierte Schließfolgeregelung Bandseite Slimdrive SD Mat. Nr. 83221, Datei 83221 SD_IS-BS_141199.p65
English
Important:
This installation instruction is based on the mounting instructions for Slimdrive SD.
For dimensions, fastening, position of electric connections and starting operation please see mounting
instructions for Slimdrive SD.
The safety regulations described therein must also be observed. If the integrated closer control is used
for other fields of application than those herein described this does not comply with the use in
accordance with the regulations.
The integrated closer control Slimdrive SD controls the closing procedure of double-wing doors featuring
overlap (typical for fire-proof doors) in a fully mechanical way:
SD-automatic function on both wings
SD-servo function on both wings
SD-servo / automatic function on the 1st closing leaf and TS 5000 on the 2nd closing leaf
The present system was designed for transom mounting on hinge side
The 1st closing leaf may be mounted left-hand or right-hand, which has to be taken into consideration
when following the below mounting instructions.
The application is possible with:
- a hinge centre
- a soffit depth
- When opening the 2nd closing leaf, an additional valve in the Slimdrive SD-IS of the 1st closing leaf,
which is located between the drives, is closed by means of a rope. The 1st closing leaf is 'waiting'.
- Once the 2nd closing leaf is nearly closed, the rope tightens, thus releasing the closing hydraulics of the
1st closing leaf.
8
Page
Fields of application
without additional transformer
incl. additional transformer
Servo
Automatic
Illustration: Transom mounting with intermediate cover (L1), hinge side
Functional description
B3
= 1200 mm B3
min
max
B3
= 1340 mm B3
min
max
max. 200 mm
max. 300 mm
= 2800 mm
= 2800 mm