Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
OPERATING INSTRUCTIONS
SL-5 SOLAR CHARGER, 6000 mAh
ITEM NO.: 1270363
INTENDED USE
This product is designed to charge batteries in mobile devices (e.g. smartphones). You can
charge up to 2 mobile devices at the same time. It contains a built in LiPo rechargeable
battery which can be charged via the solar panel or via a USB power source. The product
features a solar charging and battery level indicator and is protected against overcharging,
overload and short circuits.
The product must not come into contact with moisture, e.g. in a bathroom, or with rain and
other similar liquids.
For safety and approval purposes (CE), you must not rebuild and/or modify this product. If
you use the product for purposes other than those described above, the product may be
damaged. In addition, improper use can cause hazards such as short circuiting, fire, electric
shock etc. Read the instructions carefully and keep them. Make this product available to third
parties only together with its operating instructions.
This product complies with the statutory national and European requirements. All company
names and product names are trademarks of their respective owners. All rights reserved.
DELIVERY CONTENT
• Solar charger
• USB cable with micro USB adapter
• Wrist strap
• Storage bag
• Operating instructions
SAFETY INSTRUCTIONS
Read the operating instructions carefully and especially observe the safety
information. If you do not follow the safety instructions and information
on proper handling in this manual, we assume no liability for any resulting
personal injury or damage to property. Such cases will invalidate the
warranty/guarantee.
a) Persons / Product
• The device is not a toy. Keep it out of the reach of children and pets.
• Do not leave packaging material lying around carelessly. These may become
dangerous playing material for children.
• Protect the product from extreme temperatures, direct sunlight, strong jolts, high
humidity, moisture, flammable gases, vapours and solvents.
• Do not place the product under any mechanical stress.
• If it is no longer possible to operate the product safely, take it out of operation and
protect it from any accidental use. Safe operation can no longer be guaranteed if
the product:
- is visibly damaged,
- is no longer working properly,
- has been stored for extended periods in poor ambient conditions or
- has been subjected to any serious transport-related stresses.
• Please handle the product carefully. Jolts, impacts or a fall even from a low height
can damage the product.
• Also observe the safety and operating instructions of any other devices which are
connected to the product.
• Never pour any liquids over electrical devices or put objects filled with liquid right
next to the device. If liquids or objects do get into the device interior, the product
must not be used any more; take the product to a repair centre.
• Never use the product immediately after it has been brought from a cold room into
a warm one. The condensation generated could destroy the product. Allow the
product to reach room temperature before connecting it to the power supply and
putting it to use. This may take several hours.
• Make sure that the cable is not pinched, kinked or damaged by sharp edges.
• Never leave the product unattended during use.
• The device housing warms up during operation. Ensure that there is sufficient
ventilation. The device housing must not be covered!
b) Rechargeable batteries
• The rechargeable battery is permanently built into the product and cannot be
replaced.
• Never damage the rechargeable battery. Damaging the casing of the
rechargeable battery might cause an explosion or a fire! Unlike conventional
batteries/rechargeable batteries (e.g. AA or AAA type), the casing of the LiPo
rechargeable battery does not consist of a thin sheet but rather a sensitive plastic
film only.
VERSION 12/14
• Never short-circuit the contacts of the rechargeable battery. Do not throw the
rechargeable battery or the product into fire. There is a danger of fire and
explosion!
• Charge the rechargeable battery regularly, even if you do are not using the
product. Due to the rechargeable battery technology being used, you do not need
to discharge the rechargeable battery first.
• Never charge the rechargeable battery of the product unattended.
• When charging, place the product on a surface that is not heat-sensitive. It is
normal that a certain amount of heat is generated during charging.
c) Miscellaneous
• Consult an expert when in doubt about operation, safety or connection of the
device.
• Maintenance, modifications and repairs are to be performed exclusively by an
expert or at a qualified shop.
If you are not sure about the correct connection or use, or if questions arise which are not
covered by these operating instructions, please do not hesitate to contact our technical
support or another qualified specialist.
OPERATING ELEMENTS
7
6
5
4
OPERATION
Check the battery level of the internal battery before each use. Fully charge
the internal battery before using for the first time. Ensure that the connection
data for your mobile device matches the values for the product (see technical
data).
Always read the operating instructions for your mobile device.
Do not short-circuit the USB ports.
The USB cable is not designed for data transfer.
a) Charging the internal battery using solar energy
Place the product with the solar cell (7) in direct sunlight to charge. Artificial light may
also be used, but it is much less efficient than sunlight. It takes at least 30 hours to fully
charge the internal battery under optimal conditions and direct sunlight.
• Charge the internal battery when a battery level of below 25 % is indicated.
• Place the product in a place with good access to light so that the solar cell can charge the
battery. Ensure that the solar cell is not covered or shaded.
• The blue LED on the charging LEDs (5) lights up and indicates that the internal battery is
being charged via solar power.
1 On/off button
8
2 OUT2 USB port (output 2)
3 OUT1 USB port (output 1)
4 Micro USB port IN (input)
5 Charging LEDs
OUT 1: green LED for output 1
OUT 2: green LED for output 2
S: blue LED; lights up when the internal
battery is charged via solar power
6 Battery status indicator (4 red LEDs)
7 Solar cell
8 Opening for wrist strap
1
3
2
Publicité
Table des Matières
