Accessories - RIB R60 Mode D'emploi

ACCESSORIES -

For the connections and the technical data of the optional equipments follow the relevant handbooks.
KS2/R2
Automatic travel and timing code learning system
Automatic closure
Pre-blinking
Slow speed in close position approach
Electronic adjustment of the force
Radio command - step by step or automatic
Single command - step by step or automatic
Directional open and close commands (with timer control)
Electric lock release operation
Stop command
Connectable to encoder to detect obstacle - photocells - strips - blinker - key selector -
buzzer - electric lock
EXPANDER CARD
!! FEED THE EXP CARD IN WHEN POWER IS NOT SUPPLIED !!
- PEDESTRIAN OPENING COMMAND
- AUTOMATIC PEDESTRIAN CLOSING
- MANAGEMENT OF THE SAFETY EDGE
- 24VAC ACCESSORIES FEEDING
- MANAGEMENT OF THE TRAFFIC LIGHT CONTR
- MANAGEMENT OF THE COURTESY LIGHT
- CLOSING COMMAND AFTER PASSING THROUGH THE PHOTOCELLS*
RADIO TRANSMITTER SUN
SUN 2CH
SUN CLONE 2CH
CODE LEARNIG SYSTEM RADIORECEIVERS
RX433/A
code ABKS160 RX433/A
RX433/A 2CH super eterodyne, 2 channel and coupling
RX433/A 2CH super eterodyne, 2 channel and terminal board
SPARK
In order to make the systems mentioned above give the best performances, you need to
install an antenna tuned on the frequency of the radio receiver installed.
N.B. Pay attention to not let the central wire of the cable to came Into contact with
the external copper sheath, since this would prevent the antenna from working.
Install the antenna vertically and in such a way the remote control can reach it.
SPARK BLINKER WITH IN-BUILT INTERMITTENT CARD
LATERAL SUPPORT
SPARK ANTENNA 433
code ACG5470
17
code ACG6052 SUN 4CH
code ACG6056 SUN CLONE 4CH
super eterodyne and coupling
super eterodyne and terminal board
G
B
code ACG6054
code ACG6058
code ACG5055
code ACG5056
code ACG5051
code ACG5052
code ACG7059
code ACG7042
code ACG5452