Automatic Boost Function - Erge KHT 30-2 Instructions De Montage Et D'utilisation

Power level
Reduction
1.
2.
3.
4.
Selected pow- Automatic boost fun-
er level
1
2
3
4
5
6
7
8
9
P
Operation
Time
ction
Time (min:sec)
01:11
02:44
04:47
05:28
06:29
01:11
02:44
02:44
07:00
-:-

3.12 Automatic boost function

Food is parboiled at power level P with the automatic boost
function. After a certain time, the power level will switch
down automatically to a lower simmering setting
(1 to 9).
When using the automatic boost function only the sim-
mering setting with which the food is to be cooked through
needs to be selected since the electronic unit switches
down automatically.
The automatic boost function is suitable for dishes which
are cold initially and are then heated up at high power.
These dishes do not need to be constantly monitored
when simmering (e.g. boiling meat for soups).
1. Switch a cooking zone on. The power setting indicator
for the selected cooking zone must light up brightly. It
may be necessary to press the cooking zone selection
key.
2. Adjusting the setting P. Pressing the Plus key
will activate the automatic boost function. The power
display will show an A.
3. Then immediately use the Minus key
lower simmering setting from 1 to 9.
4. The automatic boost function will operate as program-
med. After a certain time (see chart) the cooking pro-
cess will be continued with the simmering setting. The
cooking level indicator A goes out.
Notes
• While the automatic boost function is in operation, the
Plus key can be used to raise the simmering power set-
ting. Pressing the Minus key will switch the automatic
boost function off .
• If, after activating the automatic boost function, the
power level is left at level P and no lower simmering
setting is selected, the automatic boost function will be
switched off automatically after 10 seconds and the
power level will remain at P.
GB
again
to select a
23