Before First Use - Unold 48935 Notice D'utilisation

BEFORE FIRST USE

When removing the appliance from the packaging, do not tilt it by more than 45 °, as
the built-in compressor might otherwise be damaged.
1. Remove all packaging and transport safety devices. Keep the packaging
material away from children. Choke hazard! Dispose of the packaging mate-
rial according to the applicable statutory waste disposal regulations.
2. Inspect the appliance for damage. If there is visible damage, to not start the
appliance but contact our customer service department.
3. Check whether all accessories listed in this manual have been shipped with
your appliance.
4. Clean all parts with a damp cloth, as described in chapter „Cleaning and
maintenance".
5. Before using the ice cube maker for the first time, we recommend running
the cleaning program described on page 29.
6. Check whether the appliance and its components are properly assembled
and make sure the appliance is standing on a sturdy and level surface.
7. Check the water outlet at the bottom of the appliance near the front to make
sure that it is properly sealed with the cap.
8. Position the ice cube maker so that there is a distance of at least 15 cm bet-
ween the appliance and any walls, cabinets and other kitchen appliances.
9. After unpacking, do not start the appliance for at least 2 hours, as the com-
pressor might otherwise become damaged.
10. Connect the appliance to a suitable power socket (220–240 V~, 50 Hz).
The ice cube maker is now in standby mode and the „Ice Making" indicator
flashes.
Stand 25.5.2021
DE
EN
FR
NL
IT
ES
PL
25 von 96