Connecting To Power Supply - Stihl HSE 60 Notice D'emploi

English

Connecting to Power Supply

The voltage and frequency of your
power supply and the voltage and
frequency specified on the unit must be
the same. Use an extension cord
specifically approved for outdoor
applications.
Extension Cords
Minimum wire size for extension cords
for 120 Volt appliances:
Cord types SJW-A or SJTW-A
Round jacketed cords.
Cord length (ft) 25 50
Wire size (AWG) 18 16
Listed by UL, W-A marking on cable
jacket indicates "outdoor use."
Appropriate extension cords are
available in special stores for electrical
equipment or from your STIHL dealer.
Extension cord reel
WARNING
If your extension cord is stored on a reel,
always unwind it completely before use.
A coiled extension cord can retard the
flow of electricity and cause overheating,
which can lead to a short circuit or fire.
The reel should be equipped with
thermal protection.
10
100 150
16 14
To reduce the risk of disconnection of
hedge trimmer cord from the extension
cord during operating and to relieve
strain on the hedge trimmer cord:
Insert unit's plug (1) into extension
N
cord coupling (2).
1 2
Strain Relief (Cord Retainer)
4
Make a loop (3) in the extension
N
cord and pass it through the
opening (4).
Slip the loop over the strain relief
N
hook (5) and pull it tight. Secure
cord in position with cord lock
lever (6).
Connecting to Wall Outlet
Connect the extension cord plug to
N
a properly installed wall outlet.
Polarized Plug
To reduce the risk of electrical shock,
this equipment has a polarized plug (one
blade is wider than the other). The
hedge trimmer plug will fit into a
polarized extension cord only one way. If
HSE 60, HSE 70
3
5
6