Height Adjustment - Nuna pipa icon Mode D'emploi

The load leg has 24 positions. When the load leg
indicator shows red this means the load leg is in the
wrong position.
Make sure the load leg is secure by pressing down on
the front of the base.
To shorten the load leg, squeeze the load leg release
button and pull the load leg upwards.
The completely assembled base is shown as
The ISOFIX connectors must be attached and locked
onto the ISOFIX anchor points.
The load leg must be installed correctly with green
(12)-2
indicator.
6 To remove the base, press the secondary lock button
(13)-2
first and then the button
before removing the base from the vehicle seat.
7 Press the ISOFIX releasing button to fold the ISOFIX.
8 Push the PIPA icon infant child restraint down into the base
(15)
, if the PIPA icon infant child restraint is secure, the PIPA
icon infant child restraint indicator shows green.
Pull up on the PIPA icon infant child restraint to be sure it
is securely latched into the base.
9 Level line on carrier must be level to the ground when the
PIPA icon infant child restraint is installed.
10 To release the PIPA icon infant child restraint, pull the infant
child restraint up while squeezing the PIPA icon infant child
(17)
restraint release button.
21
(11)
(12)
(12)-1
(13)-1
on the latch connectors
(14)
(16)
(41)

Height Adjustment

for Head Support and Shoulder Harnesses
Check that Shoulder Harness Straps are set at the proper height.
Please choose the proper pair of shoulder harness slots according
to the child's height.
Shoulder Harness Straps must go into the harness slots
nearest to your childs shoulders
(19)
shoulder line.
If the Shoulder Harness Straps are not at proper height, the
child might be ejected the PIPA icon infant child restraint if
there is a crash.
Squeeze the head support adjustment lever
pull up or push down the head support until it snaps into one of
the 7 positions. The head support positions are shown as
(18)
, but not above the
(20)
, meanwhile
(21)
.
22