Installation Concerns; Aeroplane Installation - Nuna pipa icon Mode D'emploi

Before carrying the PIPA icon infant child restraint
by hand, ensure that the child is fastened with the
safety harness, and that the handle is correctly
locked in a vertical position.
To avoid serious injury or death, NEVER place PIPA
icon infant child restraint on elevated surface seat
with child in it.
The parts of this PIPA icon infant child restraint
should not be lubricated in any way.
Always secure child in PIPA icon infant child
restraint, even on short trips, as this is when most
accidents occur.
DO NOT use this PIPA icon infant child restraint
for more than 5 years after the purchase date as
parts may degrade over time, or from exposure
to sunlight, and may not perform adequately in a
crash.
Please keep this PIPA icon infant child restraint
away from sunlight, otherwise it may be too hot for
child's skin. Always touch test seat before placing
child in it.
Frequently check the ISOFIX guides for dirt and
clean them if necessary. Reliability can be effected
by ingress of dirt, dust, food particles etc.
DO NOT place any objects in the load leg area in
front of your base.
Correct Installation is only permitted by use of the
ISOFIX connectors.
After your child is placed in this PIPA icon infant
child restraint, the safety belt must be used
correctly, and ensure that any lap strap is worn low
down, so that the pelvis is firmly engaged.
DO NOT use any load bearing contact points
other than those described in the instructions and
marked on the PIPA icon infant child restraint.
17

Installation Concerns

This PIPA icon infant child restraint with the Base is
suitable for vehicle seats with i-Size ISOFIX anchor
points. (1)
DO NOT place rear-facing PIPA icon infant child
restraint on front seat with air bag. Death or serious
injury may occur. (2) Please reference vehicle
owner's manual for more information.
DO NOT install this PIPA icon infant child restraint
on vehicle seats that face sideways or rearward with
respect to the moving direction of the vehicle. (3)
It is recommended to install this PIPA icon infant
child restraint on the rear vehicle seat. (4)
DO NOT install this PIPA icon infant child restraint
on vehicle seats unstable during installation.

Aeroplane Installation

The Nuna PIPA icon can only be installed using a
2-point safety belt if being used in an aircraft.
DO NOT install in a vehicle using a 2-point safetybelt.
When being used in an aircraft, the child restraint must
only be installed rear facing on the seat.
Nuna child restraint width is 450mm, but some aircraft
seat widths are 430mm. For narrow seat, please place
padding under the seat to raise the height and allow it
to fit between the arm rests.
This child restraint's base is NOT certified for use in
aircraft.
18