Tare Function/Measuring In A Container; Measuring Liquids; Hold Function (Hold); Changing The Batteries - SilverCrest SDL 300 C2 Mode D'emploi

♦ You can repeat this procedure until you have
reached 3000 g in total weight . If 3000 g is
exceeded, the display 2 shows "
NOTE
► You cannot use the TARE function while you
are adding weights!

TARE function/measuring in a container

♦ If you want to weigh food in another container,
place the container in the spoon 1 first .
♦ Then press the ON/TARE button 4 to reset the
display to zero .
♦ When you add the food to the container, only
the weight of the food itself will be displayed .
If you take the container with the food off the
spoon 1, a negative value will be displayed .
♦ Now press the ON/TARE button 4 again to
return to the normal weighing mode .

Measuring liquids

The scale in the spoon 1 can be used for measuring
liquids (15–45 ml or 1–3 tablespoons) .
However, due to optical displacement, differences
of up to 15% can occur .

Hold function (HOLD)

If you press the HOLD button 6 while a weight is
being displayed, the weight display will be retained
even if you remove the contents from the spoon 1 .
If you then press the HOLD button 6 again, you
will deactivate the hold function and the current
weight will be displayed again .

Changing the batteries

As soon as the battery becomes low, the " " symbol
will be shown on the display 2 to remind you to
replace the battery soon . When "
on the display 2, the battery is empty .
You should then replace the battery:
♦ Remove the cover of the battery compartment 5 .
♦ Take out the empty battery, and replace it with
a new 1 .5 V AAA/LR03 battery . Ensure that the
battery has the correct polarity .
♦ Close the battery compartment 5 .
│ GB │ IE
■ 8
" .
" appears
SDL 300 C2