GE KITCHEN HUB UVH1301 Manuel D'utilisation Et Instructions D'installation page 27

C. OUTSIDE BACK EXHAUST
C6
MOUNT THE KITCHEN HUB™
CAUTION
To avoid the
risk of personal injury (back
injury or other injuries due to
excessive weight of the unit)
or property damage, you will
need two people to install
this product.
IMPORTANT: Do not put any pressure on front
screen during installation.
WARNING
Risk of Electric Shock. Can
cause injury or death: If installing unit with metal
cabinets, cover the edge of the power supply
cord hole with the nylon grommet in hardware
bag.
IMPORTANT: If filler blocks are not used, case
damage may occur from overtightening screws.
NOTE: When mounting the unit, thread power cord
through hole in bottom of top cabinet. Keep it tight
throughout Steps 1–3. Do not pinch cord or lift unit
by pulling cord.
1. Lift unit, tilt it forward, and hook slots at back bottom
edge onto four lower tabs of mounting plate.
49-2000492 Rev. 2
Installation Instructions
(Horizontal Duct) (Cont.)
C6
MOUNT THE KITCHEN HUB™
(Cont.)
2. Rotate front of unit up against cabinet bottom.
3. Insert 2 self-aligning screws (1/4"-28 x 3-1/4")
through top-center cabinet hole. Turn two full
turns on each screw.
Cabinet Front
Cabinet Bottom Shelf
Self-Aligning Screw
Unit Top
4. Tighten the 2 screws to the top of the unit. (While
tightening screws, hold the unit in place against
the wall and the top cabinet.)
C7
FINALIZE INSTALLATION
Plug in the unit.
Filler Block
This
Equivalent
distance
to Depth
can NOT
of Cabinet
exceed 2"
Recess
to ensure
proper
installation
27