GE KITCHEN HUB UVH1301 Manuel D'utilisation Et Instructions D'installation page 16

1. PLACEMENT OF THE MOUNTING PLATE (Cont.)
D
ALIGNING THE MOUNTING PLATE
Hole A
Hole C
CAUTION
Wear gloves to protect against
sharp edges.
1. Draw a vertical line on the wall at the center of the
2. Use the mounting plate as the template for the rear
wall. Place the mounting plate on the wall, making
sure that the tabs are touching the bottom of the
cabinet or the level line drawn in Step C for cabinets
with front overhang. Line up the notch and center line
on the mounting plate to the center line on the wall.
3. While holding the mounting plate with one hand,
draw circles on the wall at holes A, B, C, and D (see
illustration above/actual plate marked with arrows) .
Four holes must be used for mounting.
16
Installation Instructions
30"
Area E
Draw a
Vertical Line
on Wall from
Center of Top
Cabinet
Notch
NOTE: Holes C and D are inside area E. If neither
C nor D is in a stud, find a stud somewhere in area
E and draw a fifth circle to line up with the stud. It is
important to use at least one wood screw mounted
firmly in a stud to support the weight of the unit.
Set the mounting plate aside.
WARNING
Risk of electric shock. Can cause
injury or death. Take care to not drill into electrical
wiring inside walls or cabinets.
4. Drill holes on the circles. If there is a stud, drill a
NOTE: DO NOT MOUNT THE PLATE AT THIS TIME.
Hole B
Hole D
49-2000492 Rev. 2