GE KITCHEN HUB UVH1301 Manuel D'utilisation Et Instructions D'installation page 20

A. OUTSIDE TOP EXHAUST
A5
MOUNT THE KITCHEN HUB™
CAUTION
To avoid the risk of personal
injury (back injury or other injuries due to
excessive weight of the unit) or property damage,
you will need two people to install this product.
IMPORTANT: Do not put any pressure on front
screen during installation.
WARNING
Risk of Electric Shock. Can
cause injury or death: If installing unit with metal
cabinets, cover the edge of the power supply cord
hole with the nylon grommet in hardware bag.
IMPORTANT: If filler blocks are not used, case
damage may occur from overtightening screws.
NOTE: When mounting the unit, thread power cord
through hole in bottom of top cabinet. Keep it tight
throughout Steps 1–3. Do not pinch cord or lift unit
by pulling cord.
1. Lift unit, tilt it forward, and hook slots at back
bottom edge onto four lower tabs of mounting plate.
2. Rotate front of unit up against cabinet bottom.
20
Installation Instructions
(Vertical Duct) (Cont.)
A5
MOUNT THE KITCHEN HUB™
(Cont.)
3. Insert 2 self-aligning screws(1/4" - 28 x 3-1/4")
through top-center cabinet hole. Turn two full
turns on each screw.
Cabinet Front
Cabinet Bottom Shelf
Self-Aligning Screw
Unit Top
4. Tighten the 2 screws to the top of the unit. (While
tightening screws, hold the unit in place against
the wall and the top cabinet.)
Filler Block
This
distance
Equivalent
can NOT
to Depth
exceed 2"
of Cabinet
to ensure
Recess
proper
installation
49-2000492 Rev. 2