GE KITCHEN HUB UVH1301 Manuel D'utilisation Et Instructions D'installation page 23

B. RECIRCULATING
B3
ADJUST BLOWER EXHAUST
The unit is shipped in the top venting mode exhaust
configuration. The vertical deflector plate should be
repositioned to the angled position.
1. Remove damper mounting plate and diverter.
2. Install diverter in angled position and reinstall
damper mounting plate.
49-2000492 Rev. 2
Installation Instructions
(Non-Vented Ductless)
B4
MOUNT THE KITCHEN HUB™
CAUTION
To avoid the risk of personal
injury (back injury or other injuries due to
excessive weight of the unit) or property damage,
you will need two people to install this product.
IMPORTANT: Do not put any pressure on front
screen during installation.
WARNING
Risk of Electric Shock. Can
cause injury or death: If installing unit with metal
cabinets, cover the edge of the power supply cord
hole with the nylon grommet in hardware bag.
NOTE: When mounting the appliance, thread power
cord through hole in bottom of top cabinet. Keep it
tight throughout Steps 1–3. Do not pinch cord or lift
unit by pulling cord.
1. Lift appliance, tilt it forward, and hook slots
at back bottom edge onto four lower tabs of
mounting plate.
2. Rotate front of appliance up against cabinet bottom.
23