Worx WG322 Mode D'emploi page 19

CAUTION: Do not touch the ground
with the chain. Ensure safety
clearance of 12".
OPERATION
1. BEFORE USING YOUR CORDLESS
TOOL
WARNING! The charger and battery
pack are specially designed to work
together so do not attempt to use any other
devices. Never insert or allow metallic objects
into your charger or battery pack connections
because of an electrical failure and hazard will
occur.
NOTE: Your battery pack is UNCHARGED and
you must charge once before use.
The battery charger supplied is matched to the
Li-ion battery installed in the machine. Do not
use another battery charger.
2. CHARGING YOUR BATTERY PACK
The Li-ion battery is protected against deep
discharging. When the battery is empty,
the machine is switched off by means of a
protective circuit.
In a warm environment or after heavy use, the
battery pack may become too hot to permit
charging. Allow time for the battery to cool
down before recharging.
3. TO REMOVE OR INSTALL BATTERY
PACK (See Fig. I1, I2, I3)
Depress the Battery Pack Release Button
to remove the Battery Pack from your tool.
After recharging, insert the Battery Pack into
the battery port. A simple push and slight
pressure will be sufficient until a click is heard.
Check to see if the battery is fully secured.
NOTE: When removing the battery pack,
hold it firmly to avoid dropping and
injury.
4. Switching on and off (See Fig. J)
ATTENTION: Check the battery
pack before using your cordless
tool. Only use the battery pack listed in
the accessories section.
20V cordless chain saw, 20V 2-in-1 pole saw/
chain saw (WG322 WG322.9 WG323 WG323.9)
For switching on the tool, press the Lock-
Out Button (15), then fully press the On/Off
Switch (2) and hold in this position. The Lock-
Out Button can now be released.
For switching off, release the On/Off Switch.
5. CUTTING
IMPORTANT: Is the oil tank filled?
Check the Oil Level Window (14)
prior to starting and regularly during
operation (See Fig. K1). Refill oil when
oil level is low. A full oil tank will last
approx. 12 minutes of cutting depending
on sawing intensity and stops.
Check recent replaced chain tension
about every 10 minutes during
operation.
1) Installing the battery pack into the machine.
2) Make sure section of log to be cut is not
laying on the ground. This will keep the
chain (7) from touching the ground as it
cuts through the log.
Touching the ground while the Chain is
moving is dangerous and will dull the
Chain.
3) Use both hands to grip saw. Always use
left hand to grip Front Handle（(4) and
right hand to grip Rear Handle (1). Use a
firm grip. Thumbs and fingers must wrap
around saw handles. (See Fig. K2)
4) Make sure your footing is firm. Keep
feet-shoulder width apart. Distribute your
weight evenly on both feet.
5) When ready to make a cut, push the Lock-
Out Button (15) completely in with the right
thumb and squeeze the trigger. This will
turn saw on. Releasing the trigger will turn
the saw off. Make sure the saw is running
at full speed before starting a cut.
6) When starting a cut, slowly place moving
chain against the wood. The wood should
be as close to the saw body as possible.
Hold saw firmly in place to avoid possible
bouncing or skating (sideways movement)
of saw.
7) Guide the saw using light pressure and
do not put excessive force on the saw,
letting the saw do its work. The motor will
overload and can burn out. It will do the job
better and safer at the rate for which it was
intended.
8) Remove the saw from a cut with the saw
running at full speed. Stop the saw by releasing
19
EN