Worx WG322 Mode D'emploi page 15

1
When bucking on a slope always stand on
the uphill side of the log, as illustrated in
1/3
Figure 6. When "cutting through" , to maintain
complete control release the cutting pressure
near the end of the cut without relaxing your
grip on the chain saw handles. Don't let the
chain contact the ground. After completing the
cut, wait for the saw chain to stop before you
move the chain saw. Always stop the motor
before moving from tree to tree.
Fig.6
SYMBOLS
To reduce the risk of injury, user
must read instruction manual
Wear ear protection
Wear eye protection
Wear dust mask
Do not expose to rain
Wear head protection
20V cordless chain saw, 20V 2-in-1 pole saw/
chain saw (WG322 WG322.9 WG323 WG323.9)
2
2/3
Wear protective gloves
Wear protective footwear
Warning of danger from
overhead electric-power lines
Contact of the guide bar tip
with any object should be
avoided
Li-Ion battery, battery must be
recycled
Tip contact can cause the guide
bar to move suddenly upward
and backward, which can cause
serious injury
Always use two hands when
operating the chain saw
POSITEC Inc. has established
a partnership with the RBRC
Corporation to recycle any Positec
batteries with the RBRC-call2recycle
seal. For environmental protection,
please do not discard batteries in
the trash. After the batteries' life
cycle is ended, then please call
1-800-822-8837 for a free service
that will properly dispose of the
battery.
15
EN