EIBENSTOCK ETR 350 P Notice Originale page 19

Safety Instructions
Safe work with the machine is only possible if you read
this operating instruction completely and follow the
instructions contained strictly. Additionally, the general
safety instructions of the leaflet supplied with the tool
must be observed. Prior to the first use, the user should
absolve a practical training. Save all warnings and
instructions for future reference.
If the mains cable gets damaged or cut during the use, do not
touch it, but instantly pull the plug out of the socket. Never use
the tool with damaged mains cable.
The tool must neither be wet nor used in humid environment.
Cut-off machine safety warnings
The guard provided with the tool must be securely attached to the
power tool and positioned for maximum safety, so the least amount of
wheel is exposed towards the operator. Position yourself and
bystanders away from the plane of the rotating wheel. The guard helps
to protect operator from broken wheel fragments and accidental contact
with wheel.
Use only diamond cut-off wheels for your power tool. Just because an
accessory can be attached to your power tool, it does not assure safe
operation.
The rated speed of the accessory must be at least equal to the
maximum speed marked on the power tool. Accessories running faster
than their rated speed can break and fly apart.
Wheels must be used only for recommended applications. For
example: do not grind with the side of cut-off wheel. Abrasive cut-off
wheels are intended for peripheral grinding, side forces applied to these
wheels may cause them to shatter.
Always use undamaged wheel flanges that are of correct diameter for
your selected wheel. Proper wheel flanges support the wheel thus
reducing the possibility of wheel breakage.
Do not use worn down reinforced wheels from larger power tools.
Wheels intended for larger power tools are not suitable for the higher speed
of a smaller tool and may burst.
The outside diameter and the thickness of your accessory must be
within the capacity rating of your power tool. Incorrectly sized
accessories cannot be adequately guarded or controlled.
The arbour size of wheels and flanges must properly fit the spindle of
the power tool. Wheels and flanges with arbour holes that do not match
the mounting hardware of the power tool will run out of balance, vibrate
excessively and may cause loss of control.
Do not use damaged wheels. Before each use, inspect the wheels for
chips and cracks. If power tool or wheel is dropped, inspect for
19