Function Keys - Technoline 35.1078.10.IT Manuel D'instructions

successful at 06:00 am, then the next attempt will take place the next day at
02:00 am.
Once the outdoor data reception test period is completed, the DCF tower icon in
the clock display will start flashing in the upper left corner. This indicates that the
clock has detected that there is a radio signal present and is trying to receive it.
When the time code is received, the DCF tower becomes permanently lit and the
time will be displayed.
If the tower icon flashes, but does not set the time or the DCF tower does not
appear at all, then please take note of the following:

Recommended distance to any interfering sources like computer monitors
or TV sets is a minimum of 1.5 - 2 meters.

Within ferro-concrete rooms (basements, superstructures), the received
signal is naturally weakened. In extreme cases, please place the unit close
to a window and/ or point its front or back towards the Frankfurt transmitter.

During nighttime, the atmospheric disturbances are usually less severe and
reception is possible in most cases. A single daily reception is adequate to
keep the accuracy deviation below 1 second.

FUNCTION KEYS:

Weather station:
The weather station has 4 easy to use function keys:
SET key
SET key

Press and hold the key to enter manual setting modes: LCD contrast, time
zone, time reception ON/OFF, 12/24 hour display, manual time setting,
calendar, temperature °C/°F, pressure hPa/inHg, relative pressure value,
and weather icon sensitivity setting

Reset all MIN/MAX records
IN key

Press to toggle between MAX/MIN and current indoor temperature/humidity
data

Decrease relative pressure value (within manual set mode)
OUT/+ key

Press shortly to toggle between MAX/MIN and current outdoor
temperature/humidity data

Increase, change, toggle all values in manual set mode
CH key

Switch among display of channels (if more than 1 transmitter is used)
IN key
OUT/+ key
27
CH key