Care And Maintenance - Technoline 35.1078.10.IT Manuel D'instructions

POSITIONING THE THERMO-HYGRO TRANSMITTER
Note:
Before permanently fixing the remote temperature/humidity sensor wall base,
pace all units in the desired locations to check that the outdoor temperature and
humidity readings are receivable. In event that the signal is not received, relocate
the remote temperature/humidity sensor or move them slightly as this may help
the signal reception.

CARE AND MAINTENANCE


Clean the instrument and the transmitter with a soft damp cloth. Do not use
solvents or scouring agents. Protect from moisture.

Remove the batteries if you do not use the product for a lengthy period.
MALFUNCTION
Problems
No indication on the
weather station
No transmitter reception
Display "---"
No DCF reception
Incorrect display
Table stand/wall
mount bracket
Troubleshooting

Ensure batteries polarity are correct

Change batteries

Check batteries of external transmitter (do not
use rechargeable batteries!)

Restart the transmitter and weather station as
per the manual

Choose another place for the transmitter
and/or the weather station

Reduce the distance between the transmitter
and the weather station

Check if there is any source of interference
Time reception setting "ON"


Choose another place for the weather station

Manual time setting

Wait for attempted reception during the night

Change batteries
The thermo-hygro transmitter can be
placed onto any flat surface or wall mount
using the bracket which doubles as a
stand or wall mount base.
To wall mount:
1. Secure the bracket onto a desired
wall using the screws and plastic
anchors.
2. Clip the transmitter onto the bracket.
37