Technoline 35.1078.10.IT Manuel D'instructions page 25

Thermo-Hygro Transmitter




TO INSTALL AND REPLACE BATTERIES IN THE THERMO-HYGRO
TRANSMITTER
The outdoor thermo-hygro transmitter uses 2 x AA IEC LR6, 1.5V
batteries. To install and replace the batteries, please follow the
steps below:
1.
2.
3.
TO INSTALL AND REPLACE BATTERIES IN THE WEATHER
STATION
Battery replacement

Replace the batteries when the battery symbol of the temperature station
appears near the indoor humidity display.

When the batteries of the transmitter are used up, the low battery icon
appears near the outdoor temperature display.
Note:
In the event of changing batteries in any of the units, all units need to be reset by
following the setting up procedures. This is due to a random security code
Remote transmission of outdoor temperature and humidity
to weather station by 868MHz
Shower proof casing
Wall mounting case
Mounting at a sheltered place. Avoid direct rain and
sunshine
Remove the battery cover at the front side with a small
screwdriver.
Insert the batteries, observing the correct polarity (see
battery compartment marking).
Replace the battery cover on the unit.
The weather station uses 3 x AA, IEC LR6, 1.5V
batteries. To install and replace the batteries,
please follow the steps below:
1. Insert finger or other solid object in the space
at the bottom center of the battery
compartment and lift up to remove the cover.
2. Insert batteries observing the correct polarity
(see marking).
3. Replace compartment cover.
24