Technoline 35.1078.10.IT Manuel D'instructions page 26

assigned by the transmitter at start-up. This code must be received and stored by
the weather station in the first 3 minutes of power being supplied to the
transmitter.
SETTING UP
WHEN ONE TRANSMITTER IS USED
First, insert the batteries in the transmitter (see "How to install and
1.
replace batteries in the thermo-hygro outdoor transmitter" above).
2. Within 2 minutes of powering up the transmitter, insert the batteries in the
weather station (see "How to install and replace batteries in the weather
station" above). Once the batteries are in place, all segments of the LCD
will light up briefly. Following the indoor temperature/humidity and the time
as 0:00 will be displayed. If these information are not displayed on the LCD
after 60 seconds, remove the batteries and wait for at least 60 seconds
before reinserting them. Once the indoor data is displayed user may
proceed to the next step.
3. After the batteries are inserted, the weather station will start receiving data
signal from the transmitter. The outdoor temperature and humidity data
should then be displayed on the Weather station. If this does not happen
after 2 minutes, the batteries will need to be removed from both units and
reset from step 1.
4. In order to ensure sufficient 868 MHz transmission however, the distance
between the weather station and the transmitter should not be more than
100 meters (see notes on "Positioning" and "868 MHz Reception").
Note:
In the event of changing batteries of the units, ensure the batteries do not spring
free from the contacts. Always wait at least 1 minute after removing the batteries
before reinserting, otherwise start up and transmission problems may occur.
WHEN MORE THAN ONE TRANSMITTER IS USED
1. User shall remove all the batteries from the weather station and
transmitters, and wait 60 seconds.
2. Insert the batteries in the first transmitter.
3. Within 2 minutes of powering up the first transmitter, insert the batteries in
the weather station. Once the batteries are in place, all segments of the
LCD will light up briefly. Following the indoor temperature/humidity and the
time as 0:00 will be displayed. If these information are not displayed on the
LCD after 60 seconds, remove the batteries from both units and wait for at
least 60 seconds before reinserting them.
4. The outdoor temperature and humidity data from the first transmitter
(channel 1) should then be displayed on the weather station. Also, the
signal reception icon will be displayed. If this does not happen after 2
minutes, the batteries will need to be removed from both units and reset
from step 1.
25