Operating Elements; Before Commissioning - Kärcher BR 40/10 C Adv Mode D'emploi

1 Lock for fresh water reservoir
2 Switch for brush drive
3 Switch for detergent solution
4 Hose for detergent solution
5 Lint sieve (suction)
6 Lock of pushing handle
7 Release button for the transport wheel
8 Transport wheel *
9 Push handle
10 Strain relief clamp
11 Support of the transport wheel *
12 Clip
13 Fresh water tank
14 waste water tank
15 Scraper roller
16 Push-button for vacuum bar change
17 Float
18 Button for brush change
19 Chassis
20 Vacuum bar
21 Brushing rollers
22 Rotating handle for brush contact pres-
sure
23 Pedal to lower vacuum bar
24 Mains plug
25 Carrying handle for waste water tank
26 Fresh water tank cover
* not included in the delivery with BR 40/10
C Classic
Colour coding
– The operating elements for the cleaning
process are yellow.
– The controls for the maintenance and
service are light gray.

Operating elements

Before Commissioning

Installing the pushing handle
 Slide the upper slider half onto the low-
er slider half.
ATTENTION
Risk of damage. Do not open cable loops
during assembly.
 Align the borings (2 possible height ad-
justments).
 Connect the slider halves to the lock
screws, discs and star grips.
 Fasten the cable to the slider using
clips.
2
-
EN
Installing the transport wheels
With the BR 40/10 C Classic, the transport
wheels are not included in the delivery. An
attachment kit with transport wheels is list-
ed in the chapter "Accessories".
 Insert the transport wheel axles into the
borings on the appliance and lock them.
Installing the Brushes
The brushes must be installed before the
initial operation (see "Maintenance works").
11