Honeywell SV2 Serie Instructions D'installation

SV2 Series Replacement Solenoids
COILABxxxV, COILCDxxxV
INSTALLATION INSTRUCTIONS
INTRODUCTION
This document provides installation instructions and wiring
information for the Honeywell SV2 Series valves replacement
solenoid assemblies. Other applicable publications are:
– 32-00018, SV2 Series Installation Instructions
– 32-00029, SV2 Series V2F User Manual
– 32-00030, HMI Tool Installation Instructions
– 32-00031, HMI/PC Tool User Manual
– 32-00037, PC Tool Installation Instructions
SPECIFICATIONS
Environmental Ratings:
NEMA 4 / IP66.
Operating Temperature Range:
Fuel/air versions (V2P/V2V): +5°F to 150°F / -15°C to 65°C
On/off versions (V2F/V2A): -40°F to 150°F / -40°C to 65°C
Electrical Ratings:
24VAC, 50/60Hz
100-120VAC, 50/60Hz
200-240VAC, 50/60Hz
Size Designations:
AB = Fits ¾ in or 1 in (DN20 or DN25) valves
CD = Fits 1 ½ in or 2 in (DN40 or DN50) valves
Sell Quantity:
One (1) per box.
INSTALLATION
When Installing This Product...
1. Read these instructions and the appropriate product
literature carefully. Failure to follow them could damage
the product or cause a hazardous condition.
2. Installer must be a trained, experienced combustion
service technician.
3. Check the ratings on the product to make sure the product
is suitable for your application. Do not exceed the ratings
on the Fuel Air Ratio Module.
4. After installation is complete, carry out a thorough
checkout of product operation as laid out in this document
and document 32-00018 (SV2 Series safety shut-off valve
Installation Instructions).
WARNING
Explosion or Fire Hazard
Can cause severe injury, death, or property damage.
• Turn off gas supply before starting installation.
• Disconnect power supplies before beginning
installation.
• More than one disconnect can be involved.
32-00038EFSP-01