Troubleshooting; Emergency Measures - Kemper SmartFil Notice D'utilisation

7.3 Troubleshooting

Fault
Not all dust
particles are
collected
Signal horn
sounds, the
green indicator
lamp in the
switch does not
light up
Extraction
capacity too
low/non-
existent
Dust particles
escape on the
clean air side
Motor
protection
switch triggers
Product will not
start up

7.4 Emergency measures

In case of fire of the product or its detection elements, the following steps
should be taken if necessary:
1. Where possible, disconnect the product from the power supply by
unplugging.
2. If present, disconnect the compressed air supply.
1502818-03
Cause
Distance between the
extraction hood and the
welding position too great
Clean air outlet obstructed
Extraction capacity too low,
damper flap in the
extraction hood is closed
Filter inserts saturated
Phase sequence
error/missing phase.
The fan is rotating in the
wrong direction
Filter inserts damaged
Motor blocked
No mains voltage
Start/stop sensor (optional
fitting) connected, but no
current detected
Welding process not yet
started
Tab. 18: Troubleshooting
Note
Move the extraction hood
closer
Keep clean air outlet free of
obstruction
Fully open the damper flap
in the extraction hood
Replace filter inserts
Changeover of two phases
in the CEE plug by an
electrician
Replace filter inserts
Have this checked by a
qualified electrician
Have this checked by a
qualified electrician
Start welding process
- 68 -
EN