Reset The System; Restore Factory Settings; Firmware Upgrade - Roborock S6 MaxV Mode D'emploi

Routine maintenance
Omni-Directional Wheel
1. Turn over the robot.
2. Use a tool, such as small screwdriver to pry out the axle and take out
the wheel.
3. Rinse the axle and the wheel with water to remove any hair and dirt.
4. Air-dry, reinstall, and press the wheel and axle back in place.
Note:
The Omni-Directional Wheel bracket cannot be removed.
Wheel
Axle
Bracket
Clean as required
31

Reset the System

If the robot does not respond when a button is pressed or cannot be
turned off, reset the system. Press the Reset button, and the robot will
reset automatically.
Note:
After resetting the system, scheduled cleanup, WiFi, and others will be restored to factory settings.

Restore Factory Settings

If the robot does not function properly after a system reset, switch it on,
then press and hold both the
"Start restoring initial version" voice alert. The robot will then be restored
to factory settings.

Firmware Upgrade

Use the mobile phone app to upgrade the robot firmware. Connect the
robot to the Charging Dock and ensure that the battery level is above 20%
before upgrading. The power indicator will flash white quickly during a
firmware update.
and Reset buttons until you hear the