Connecting To The App - Roborock S7 Pro Ultra Manuel D'utilisation

B1-4— Place the dock on a hard and flat floor
(wood/tile/concrete etc.), flat against a
wall. Keep at least 0.5 m (1.6 ft) of
clearance on either side, 1.5 m (4.9 ft)
in front, and 1 m (3.3 ft) above. Make
sure the location has good WiFi for a
better experience with the mobile
app, and then plug it in.
B1-5—more than 0.5 m (1.6 ft)
B1-6—more than 1.5 m (4.9 ft)
B1-7—more than 1 m (3.3 ft)
Notes:
• If the power cable hangs vertically to the ground, it may
be caught by the robot, causing the dock to be moved or
disconnected.
• The dock indicator is on when the dock is powered on, and
off when the robot is charging.
• The dock indicator turns red if an error occurs.
• Place the dock on a flat floor away from fire, heat, and
water. Avoid narrow spaces or locations where the robot
may be suspended in the air.
• Placing the dock on a soft surface (carpet/mat) may cause
the dock to tilt over and cause problems docking and
departing.
• Keep the dock away from direct sunlight or anything that
may block the dock location beacon; otherwise, the robot
may fail to return to the dock.
• Do not use the dock without clean water tank, dirty water
tank, high-speed maintenance brush, dustbin, dust bag or
water filter.
• Maintain the dock according to the maintenance
instructions. Do not clean the dock with a wet cloth or
tissue.
• All docks are subject to water-based tests before leaving the
factory. It is normal that a small amount of water remains in
the waterway of the dock.
Power on and charge the
B2
robot
Press and hold the button to power on
the robot. When the power light goes on,
place the robot on the dock to charge. Make
sure the charging dock power indicator
turns off and a "charging" voice alert sounds.
To maintain the performance of the high-
performance lithium-ion rechargeable
battery pack, keep the robot charged.
Note: The robot may not be turned on when the battery
is low. In this case, connect the robot to the dock.

Connecting to the App

This robot supports both Roborock and
Xiaomi Home apps. Choose the one that
best meets your needs.
❶ Download App
Option 1: Search for "Roborock" in the App
Store or Google Play or scan the QR code to
download and install the app.
07
Option 2: Search for "Xiaomi Home" in the
App Store or Google Play or scan the QR
code to download and install the app.
❷ Reset WiFi
1. Open the top cover and find the WiFi
indicator.
2. Press and hold the and
you hear the "Resetting WiFi" voice alert.
The reset is complete when the WiFi
indicator flashes slowly. The robot will then
wait for a connection.
Note:
If you cannot connect to the robot due to your router
configuration, a forgotten password, or any other reason, reset
the WiFi and add your robot as a new device.
❸ Add device
Open the Roborock App, tap the "Search for
device" button, or open Xiaomi Home app,
tap "+" in the top right corner and add the
device as instructed in the app.
Notes:
• The actual process may vary due to ongoing app updates.
Follow the instructions provided in the app.
• Only 2.4 GHz WiFi is supported.
• If the robot waits more than 1 hour for a connection, WiFi
will be automatically disabled. If you want to reconnect,
reset the WiFi before proceeding.
buttons until