Water Filter - Roborock S7 Pro Ultra Manuel D'utilisation

VibraRise Mop Cloth
C8
* Clean after each use and replace every 3-6 months.
C8-1— Remove the VibraRise mop cloth from
the VibraRise mop mount. Clean the
VibraRise mop cloth and air-dry it.
Note: A dirty VibraRise mop will affect the mopping
performance. Clean it before use.
C8-2— Slide the mop cloth in from the
opening of the attachment slot then
stick it flat in place.
Robot Sensors
C9
* Clean monthly.
Use a soft, dry cloth to wipe and clean all
sensors, including:
C9-1— Dock Locator
C9-2— Wall Sensor
C9-3— Mop Wash Sensor
C9-4— Carpet Sensor
C9-5— Cliff Sensors
Charging Contact Areas
C10
* Clean monthly.
Use a soft dry cloth to wipe the charging
contacts on the robot and the dock.
Battery
The robot is equipped with a built-in
high-performance lithium-ion rechargeable
battery pack. To maintain battery
performance, keep the robot charged
during normal use.
Note: If the robot will be left unused for a long period, turn it
off and charge it at least every three months to avoid battery
damage caused by over-discharge.
Moving the Dock
C11
Remove the water tanks and the dustbin
before moving the dock. Grip the handle on
the back with one hand and the inner side
of the front, as shown. Do not grip the base
because as it is not designed for lifting.
Dirty Water Tank
C12
* Clean as required.
Clean the dirty water tank as needed. Open
the dirty water tank lid and pour out the
dirty water. Fill the tank with clean water,
close the lid, lock it, and shake. Pour out the
dirty water. Close the lid and then re-install.
High-Speed Maintenance
C13
Brush
* Clean as required and replace every 6-12 months.
Lift the high-speed maintenance brush latch
and remove the brush, as shown below.
Remove any entangled objects in the
high-speed maintenance brush and rinse it
clean. Reinstall the brush and latch it in place.
11

Water Filter

C14
* Clean as required.
Unlock the water filter and remove it for
washing. Use a soft, dry cloth to wipe the
cleaning tank, and then reinstall the filter.
Press down the filter until you hear it lock
with a click.
Replacing the Disposable
C15
Dust Bag
Replace the disposable dust bag when it is full.
*
C15-1— Lift the dustbin and remove the
bag vertically as shown.
Note: Pulling the dust bag handle to remove the bag will seal
the bag to prevent leakage.
C15-2— Discard the dust bag and clean
around the filter with a dry cloth.
C15-3— Slot in a new disposable dust bag
as shown. Slide until it reaches the
bottom of the slot and reinstall the
dustbin securely.
Note: Always install a dust bag before putting back the
dustbin top lid to avoid auto-emptying without the bag. You
can also disable auto-emptying in the app.
Cleaning the Air Duct
C16
* Clean as required.
Follow the following steps to clean the air
duct and avoid blockages.
C16-1— Remove the clean water tank, dirty
water tank, and dustbin.