Repair; Accessories - Festo EGSA Notice D'utilisation

EGSA
the ball screw inside the cantilever
profile every 4 million switching cycles.
To do this, remove the blanking plugs
on the lubricating hole 4 on both
sides and move the cantilever profile
to the retracted end position.
9

Repair

Recommendation:
S
Send the EGSA to our repair service. This ensures that the necessary fine
adjustments and checks will be carried out.
Information on spare parts and aids can be found at:
S
www.festo.com/spareparts
10

Accessories

Please note
S Please select the appropriate accessories from our catalogue
www.festo.com/catalogue
Description
Lubricating grease, recommended
Guide system
Spindle nut
Lubricating grease, alternative
Guide system
Spindle nut
1)
The alternative grease only meets the minimum requirements, and thus may not
achieve the same performance as the recommended special lubricating grease.
2)
See spare parts catalogue at www.festo.com/spareparts
Fig. 18
30
Fig. 17
Type
Klüber STABURAGS NBU 8 EP
Klüber MICROLUBE GBU−Y 131
1)
Lubricating grease DIN 51825 KP 1 N
Lubricating grease DIN 51825 KP 2 K or
LUB−KC1 from Festo
4
2)
Festo EGSA 0711NH English