Reference Standards; Data Plate; Transport And Installation - Cola ENEA Manuel D'installation, D'utilisation Et D'entretien

1.6 Reference standards

Standard EN 13240 :
design, fabrication, construction, safety and performance, instructions and markings, together with the relevant
approval test methods.
Standard UNI 10683 :
or other solid biofuels.
Standard UNI EN ISO 17225-5 :

1.7 Data plate

The data plate is located on the back of the stove. It gives the following data:
model;
-
serial number;
-
- type of fuel;
heat output;
-
- max. consumption;
dust emissions;
-
min. flue draught;
-
1.8 Instructions for ordering replacement parts
For the end-user:
Contact the service centre and/or your dealer to order replacement parts.
For the dealer:
To request any replacement parts, contact the Cola s.r.l. assistance service and/or send a fax clearly specifying the
following:
- stove model;
serial number;
-
date of purchase;
-
list of replacement parts;
-
details of faults detected.
-
- Operations on components must be carried out by authorised and/or qualified personnel.
- Only use Cola original replacement parts.
1.9 Stove decommissioning
For its disposal, the stove must be sealed inside strong packing; contact the competent local authorities for
information on how to proceed according to the current local regulations.
2

TRANSPORT AND INSTALLATION

–
2.1 Packing, handling, shipment and transport
The stove can be lifted using a lift truck, inserting the forks (of suitable length) in the special spaces in the wooden
packing. Make sure the equipment used for lifting and transport can take the weight of the stove, specified on the
data plate and in this manual.
Avoid taking the load in areas where it could be a danger if dropped.
Set the stove down on the floor carefully without jolting and position it in the required place, after making sure the
floor can take the weight of the stove; otherwise consult a specialised technician.
2.2 Instructions for safe installation
Proper operation of a heating and cook stove depends above all on its installation, which must be carried out by a
competent person, in compliance with the current safety regulations.
The stove must only be operated with the ash pan inserted, and disposal of the products of combustion must take
place daily, avoiding excessive deposits that can affect its safe operation.
The sides and back must be 20 cm ( fig.5 –ref A_B) from flammable materials.
No flammable material or objects must be placed less than 100 cm (fig.5 –ref.C) in front of the fire door. If the floor
is made of combustible material (wood, carpet, etc.), a protection base in 2-3 mm thick sheet metal or other non-
flammable material of a certain thickness must be provided; in this case the base should protrude at least 50 cm
from the front and 20 cm from the sides of the stove.
European standard for solid fuel burning stoves, containing the technical requirements for
Italian Standard specifying the installation requirements for heat generators burning wood
Technical standard regarding the characteristics of biofuels, such as firewood.
- average flue gas temperature;
- thermal efficiency;
- flue pipe size;
- stove external dimensions;
- minimum safety distances;
- weight.
24
ENEA – ENEA FORNO