Installation Check - Lenze ECSEE Serie Instructions De Montage

5

Installation check

5 Installation check
After completing the installation, check ...
The wiring for completeness, short circuit and earth fault.
ƒ
The power connection:
ƒ
–
Mains connection via terminals L1, L2, L3 (X21)
–
Connection of RFI filter / mains choke
–
Connection of brake resistor (internal/external) via terminals BR0, BR1
(X22)
–
Polarity of the DC−bus voltage supply via terminals +U
Control connection (X6):
ƒ
–
Supply of 24 V supply, GND
–
Thermal detector contact of external brake resistor or bridge if internal
brake resistor is used at terminals T1, T2.
–
Wiring adjusted to the signal assignment of the control terminals.
Communication via system bus (CAN).
ƒ
)
Note!
The next step is the commissioning. Relevant information can be
found in the detailed documentation of the power supply module.
ƒ
ƒ
86
Read the detailed documentation before switching on the power
supply module!
Perform the commissioning according to the instructions in the
detailed documentation!
l
, −U (X22)
G G
EDKCSEE040 DE/EN/FR 3.0