Flush Cutting - Husqvarna WSC 40 Manuel D'utilisation

When the cuts with the blade are finished, replace the
blade with the wall saw chain attachment and cut the
remaining material to get sharp corners.
If you are cutting in a heavily reinforced concrete or hard
aggregate you should start the cut A minus 50 mm (2")
from the corner. Check table under overcutting for A
measurements.
CAUTION! Change the setting in the remote control to
chain mode when using the wall saw chain attachment.
Feed the wall saw chain attachment inwards in the wall
and cut with the nose wheel. The software will
automatically adjust the longitudinal feeding to make the
cut with the nose wheel. Make sure that there is enough
room for the saw carriage to the end stop of the track
when cutting starts (choose the correct direction of the
arm rotation).
CAUTION! Make sure that chain mode is selected in the
remote control. If not, the tool will suffer excessive wear.
Overcutting
The overcutting length depends on the thickness of wall
and what blade that is used.
Blade size 800 mm/32"
T (mm/inch) A (overcutting mm/inch)
200/8 100/4
250/10 160/6
300/12 250/10
14/350 -
16/400 -
OPERATING

Flush cutting

Remove the spray guards for normal cutting and the
transmission cover. Replace the spray guards with the
provided guards for flush cutting.
We recommend that both flush guards are fitted but in
some applications (sawing aligned to the floor or the
ceiling) one guard might be temporarily removed. At least
the guard in the chain direction must be fitted. Replace
the guard after cutting.
T
A
1000 mm/40"
80/3
120/5
160/6
230/9
335/13
–
English 15