GE Monogram ZGP364LDNSS Manuel Du Propriétaire page 39

Before you
call for service
49-85246-1
Problem
Timer Does Not Work
Oven Temperature Too
Hot Or Too Cold
Oven Door Will Not Open
After A Clean Cycle
"Err Turn Surface
Burners Off" Scrolls In
The Display
"Close Door" Scrolls In
The Display
Is On When You Want
To Cook
F- And A Number Flash
In The Display
Display Goes Blank
Unable To Get The
Display To Show "Sf"
"Probe" Appears In The
Display
Shows In Display
Power Outage
Steam From The Vent
Burning Or Oily Odor
Emitting From The Vent
Strong Odor
Fan Noise
Troubleshooting Tips
Possible Cause
The timer cannot be used while the oven is self-cleaning.
Oven thermostat needs adjustment. See the Oven thermostat adjustment
section.
The oven is too hot. Allow the oven to cool below locking temperature.
Self-clean is in progress and the Cooktop Lockout feature is activated. No
surface cooking is permitted during the self-clean operation. Wait until the
self-cleaning operation has been completed.
The self-clean cycle has been selected but the door is not closed.
Close the oven door. The
The oven door is locked because the temperature inside the oven has not
dropped below the unlocking temperature. Turn the Oven Mode Selector
and the Temperature knobs to OFF. Allow the oven to cool.
The oven has a function error code. Turn the Oven Mode Selector and the
Temperature knobs to OFF. Allow the oven to cool for one hour. Put the
oven back into operation.
Disconnect all power to the oven for 30 seconds and then reconnect
power. If the function error code repeats, call for service.
The display is blank when the oven or timer is not in use.
A fuse in your home may be blown or the circuit breaker tripped. Replace
the fuse or reset the circuit breaker.
The TIMER and the MINI-KNOB buttons must be pushed at the same time
and held for 4 seconds.
This is reminding you to enter a probe temperature after plugging in the
probe. Enter a probe temperature
The Sabbath mode has been selected.
If the oven was in use during a power outage or surge, the oven must be
reset. Turn the Temperature knob and the Oven Mode Selector to OFF.
Reset the controls to begin again.
When using the convection mode, it is normal to see steam coming out
of the oven vent. As the number of racks or amount of food being cooked
increases, the amount of visible steam will increase.
This is normal in a new oven and will disappear in time.
This is temporary. An odor from the insulation around the inside of the
oven is normal for the first few times the oven is used.
A cooling fan or a convection fan (depending on the function you are
using) may turn on. This is normal. The cooling fan will turn on to cool
internal parts. It may run after the oven is turned off. The convection fan
may cycle on and off until the function is over or the door is opened.
Professional All-Gas Range
symbol will appear in the display
39