Cooktop Controls; Electronic Ignition & Automatic Reignition; To Light A Surface Burner; Dual-Flame Stacked Burners - GE Monogram ZGP364LDNSS Manuel Du Propriétaire

Electronic
ignition &
automatic
reignition
To light
a surface
burner
Dual-flame
stacked
burners
10
The range is equipped with electronic ignition
which eliminates the need for a standing
pilot light.
The burners on this range will automatically
relight if the flame goes out.
All surface burner igniters will spark and make
clicking sounds when any burner is turned on.
Do not touch any of the burners when igniters
are clicking.
Occasionally the burners may spark if excess
wind or a draft blows the flame away from the
burner's flame sensor.
Push the control knob in and turn it
counterclockwise to the LITE position.
WARNING
Burners should be
operated only when covered by cookware.
Burner flames not covered by cookware
present a risk of fire or clothing ignition.
Never let flames extend beyond the sides
of the cookware. Failure to comply may
result in serious injury.
All surface burners on your range have two
sets of flames stacked one on top of the other;
the dual-flame burners have a lower (simmer)
flame and a upper (main) flame.
When a burner is turned on, the lower flame
will always light and stay on.
Simmering:
The stacked burner design provides a wide
range of heat settings with which to simmer.
Depending on the type and quantity of food,
and pan size, the flame can be adjusted to suit
your specific need. The lowest setting uses
only the lower flame and can maintain delicate
foods at a safe 140°F.

Cooktop Controls

The griddle and IR (infrared) grill are equipped
with Glo-Bar igniters. The Glo-Bar remains
energized whenever the griddle or IR grill is in
use to ensure the burner always stays lit.
In case of a power outage, you can light the
surface burners on your cooktop with a match.
Hold a lighted match to the burner, then turn
the knob to the LOW position. Use extreme
caution when lighting burners this way.
Do not attempt to light the grill or griddle
during a power outage. The gas to these
burners will automatically shut off during a
power outage.
After the burner ignites, turn the knob to
adjust the flame size.
To turn a burner off, turn the knob clockwise,
as far as it will go, to the OFF position.
Do not operate a burner for an extended
ON Indicator
Light
period of time without cookware on the
grate. The finish on the grate may chip
without cookware to absorb the heat.
The indicator light on each bezel verifies the
burner is on. However, it should not be a
substitute for visually checking the flame at
the burner.
Cooking:
Settings from LO to X-HI will use both upper
and lower flames. Use LO to HI for all purpose
cooking. Use HI or X-HI (highest setting) with
larger diameter cookware.
X-HI and HI are very high heat settings and
are intended to sear foods quickly and boil
large quantities of water.
Professional All-Gas Range
Lower
Flame
Upper Flame
Lower Flame
49-85246-1