Installing The Welding Wire; Threading The Welding Wire - ESAB MobileFeed 301 AVS Manuel D'instructions

4 INSTALLATION
5. Put the knurled screw (3) back in position on the drive roll (4) and tighten it.
6. Thread the wire and fasten the pressure roll assembly (2).
4.4

Installing the welding wire

CAUTION!
Turn off the power source and the wire feeder.
1. Remove the spool retainer nut (1).
2. Put the wire spool (2) on the hub to rotate counterclockwise as the wire unwinds. The
hub pin must engage the hole in the wire spool.
3. Install the spool retainer nut (1).
4.5

Threading the welding wire

CAUTION!
Before threading the wire, make sure that the chisel point and burrs have been
removed from the end of the wire to prevent the wire from jamming in the torch
liner.
1. Turn off the power source and the wire feeder.
2. Release the pressure roll assembly lever and lift the pressure roll assembly up.
3. Check that the drive roll, groove position, and wire guides are correct.
4. Feed the wire from the spool through the inlet guide along the drive roll groove and into
the outlet guide tube.
0558 012 633 - 13 - © ESAB AB 2015