Look 987 Notice D'instructions page 22

Table des Matières

Publicité

Les langues disponibles
  • FR

Les langues disponibles

  • FRANÇAIS, page 1
Mounting the LOOK patented E-Post into
the frame enables the seatpost from never
slipping down, and with elastomer system
that absorbs the vibrations both vertically
and horizontally. These functions are
operated by acting on a single bolt that only
requires 5N.m verses 15N.m on a traditional
seatpost clamp, and reduces the stress in
the area.
WARNING: Never set the E-Post beyond
the "STOP" indication line.
Do not paste any adhesives on the carbon
elements.
Cleaning: use soapy water only.
-
Mounting the E-Post into the frame
OPERATIONS:
1/ Cutting the saddle tube at the desired
height
2/ Installation of the E-Post into the frame
IMPORTANT: the tube cutting procedure
being
non-reversible,
respect the following instructions. In
case the saddle's height is not known with
certainty, proceed in two steps by first
cutting the tube at a superior height (to
do so, lessen the length to cut, mentioned
below in the procedure, by a few mm).
REMEMBER: You can always cut more
if needed. But, you CANNOT add more
when already cut.
EN
scrupulously
23

Publicité

Table des Matières
loading

Ce manuel est également adapté pour:

989

Table des Matières