Look 987 Notice D'instructions page 21

EN
The 3 elastomers included are different
density to choose from:
BLACK ELASTOMER: FIRM (95 shore)
RED ELASTOMER: MEDIUM (84 shore)
GREY ELASTOMER: SOFT (64 shore)
1 – Completely remove screw A using a 4mm
hex key.
2 – Remove cap F.
3 – Slide toward the bottom the E-post,
the 2 pads and the 2 spacers.
4 – Remove the elastomer by sliding it toward
the bottom of the E-post.
5 – Do not remove the support washer
(Fig. B).
6 - Insert a new elastomer through the base
of the E-post (Fig. C)
7 -Insert without changing the order 1 spacer,
1 pad, and once again 1 spacer and 1 pad.
8 - Insert the cap.
9 – Tighten screw A in the cap using a 4mm
hex head key.
22
-
Changing an elastomer
A: Screw
B: Support washer
C: Elastomer
D: Spacer x 2
E: Pad x 2 (red)
F: Stopper
D
A
B
C
E
F