Chicco Go-One Mode D'emploi page 27

Siège d'auto
Table des Matières

Publicité

Les langues disponibles
  • FR

Les langues disponibles

  • FRANÇAIS, page 15
ply with the instructions herein may affect your
child's safety.
The child car seat is intended for children
weighing between 9 kg and 18 kg.
The child car seat may be fitted to the front
passenger seat or any rear seat, always in a
front-facing position. Never use this child car
seat on side-facing or rear-facing car seats (Fig.
4).
The car seat must be fitted with a 3-point
static or 3-point retractor safety belt, type ap-
proved to UN/ECE Regulation No. 16, or other
equivalent standards (Fig. 5).
WARNING! According to car accident statistics,
the rear seats of a car are generally safer than
the front seat: it is therefore recommended to fit
the child car seat onto the vehicle's rear seats. In
particular, the central rear seat is the safest, if it is
equipped with a 3-point safety harness: in this
event, it is recommended to fit the child car seat
into the vehicle's central rear seat.
If the child car seat is fitted onto the front seat of
the car, it is recommended to push the seat back
as much as possible, bearing in mind the comfort
of the passenger sitting in the seat directly behind
it, and, to then adjust the backrest in the most ver-
tical position. If the car is equipped with a safety
belt height adjuster, fix it in the lowest position.
Then check that the car seat safety belt adjuster is
either in a backward position with respect to the
backrest of the car seat (or at least aligned to it)
(Fig. 5 refers).
If the front seat is equipped with a frontal airbag, it
is recommended not to fit the child car seat onto
this seat. If you wish to fit the child car seat in any
seat protected by airbag, always refer to the vehi-
cle instructions manual.
WARNING! Never install the child car seat on a car
seat equipped only with a 2-point horizontal lap
belt. (Fig. 6)
Make sure that the buckle seat belt is not too
high (Diag 10). Otherwise, try to install the car
seat for your child on another car seat in the
car.
CHILD CAR SEAT INSTALLATION INTO THE
VEHICLE
WARNING! ENSURE THAT THE CAR SAFETY BELT
IS NEVER FITTED IN WAYS THAT ARE DIFFERENT
TO THE POSITIONS SPECIFIED IN THIS INSTRUC-
TION BOOKLET. UNAUTHORISED SAFETY BELT
POSITIONING WILL COMPROMISE YOUR CHILD'
SAFETY!
The correct safety belt positions are highlighted
in red.
WARNING! Both instructions and figures are for
the installation of the child car onto the vehicle's
right rear seat. To fit the child car seat in other po-
sitions, the operations must still be carried out in
the same order.
1. Place the child car seat onto the selected ve-
hicle seat. WARNING! Check that there are no
loose objects between the child car seat and
the vehicle seat or between the child car seat
and the vehicle door.
2. Recline the child car seat backrest entirely by
pulling the lever (O), located under the child
car seat, forward towards you (Fig. 7).
3. Pull on the car safety belt and lead it in through
the space located between the child car seat
backrest and the child car seat base frame.
(Fig. 8).
4. Lead the 3-point Car safety belt horizontal strap
into the appropriate safety belt guides.(Fig. 9).
5. Pull out from the other side of the child car seat
and lock it to the seat buckle (Fig. 10).
6. Open the car safety belt diagonal strap lock
clamp (R) located on the same side of the seat
buckle, by pressing down on its lever (Fig. 11).
7. Slip in the car safety belt diagonal strap po-
sitioning it exactly as illustrated in fig. 12.
Release the lever of the lock clamp (R), it will
automatically retract into its lock position.
8. Pull very firmly on the car safety belt diagonal
strap, ensuring that the child car seat is very
tightly lodged to the vehicle seat (Fig. 13). If
necessary, use one knee to press down on the
child car seat.
9. Insert the upper part of the diagonal belt in-
side the T guide, placing it exactly as shown in
diagram 14.
10. Pull the safety belt in the direction shown in
diagram 14 firmly to tighten also the last part
of the belt.
11.Check overall installation to make sure that the
child car seat is fitted correctly (Fig. 15).
WARNINGS FOR CORRECT CHILD CAR SEAT
INSTALLATION
WARNING! To avoid safety hazards, after installa-
tion, ALWAYS check to make sure that:
- the car safety belt is absolutely not twisted
anywhere;
- the car safety belt is correctly tensioned in all
areas;
- the child car seat is well locked onto the ve-
hicle seat. If it is not, go through the whole
installation procedure from the start.
PLACING THE CHILD INTO THE CHILD CAR
SEAT
- Before seating the child, press the strap ad-
27

Publicité

Table des Matières
loading

Table des Matières