Rexel Optimum AutoFeed+ 45X Mode D'emploi page 6

Optimum AutoFeed shredding capability
CAN shred the following:
• Stapled paper, 25mm within the corner
• 26/6 and 24/6 or smaller staples
• Small sized paper
• Paperclipped paper, 25mm within the corner
• Capable of shredding small/medium paperclips
(max. wire thickness = 0.9 mm)
• >80/100gsm paper
CAN shred (through the manual feed slot):
Thick paper or card
<200gsm
CANNOT shred the following:
Heavy duty staples. Check
the staple leg length is not
greater than 6mm.
Bulldog clips
Adhesive labels.
Lubrication of the shredder
Only use Rexel Oil Sheets (2101948 & 2101949) to lubricate.
ACCO Brands accepts no liability for product performance or
safety when other types of lubricants are used on any part(s) of
this machine. Rexel recommend using an oil sheet after the bin
has been emptied three times (and every three bin emptying after
this). Insert the oil sheet into the manual feed slot and NOT in the
auto-feed chamber. Using an oil sheet in the auto-feed chamber
will contaminate the feed rollers preventing the auto-feed
mechanism shredding. Follow the maintenance instructions if the
rollers become contaminated.
6
No aerosols
• A3 folded in half max. 2 sheets
• 300 sheets
• 80 gsm paper
Glossy paper or a sheet
covered with print on both
sides.
Large clips. Check the
length of the paperclip is
not longer than 32mm.
Bound documents
No Oil, only oil
sheets
Maintenance
The rollers on the auto-feed mechanism may become dirty over
time, please wipe clean with a dry cloth to maintain maximum
product performance.
The auto-start infrared sensor, located in the paper feed entry-
slot, can occasionally become covered in paper-dust causing
the shredder to run despite no paper being fed into the machine.
Switch the shredder off at the rear of the machine and carefully
clean the sensor using a cotton-swab.
Serviceable machines
(for 300 sheet and above)
We recommend these machines are serviced every 6 to 12
months by a Rexel service engineer – see www.rexeleurope.com/
support for enquiries about maintenance contracts.
- A4 - 210mm x 297mm
- A5 - 148mm x 210mm
- A3 single sheet folded in half to make A4
Multiple folded sheets
(A3 sheets folded in half).
Plastic sheets, laminated
documents, plastic
folders.
Magazines or other
documents bound by
multiple staples or clips.
CDs & DVDs