When The Indicators Provide No Help - Epson Dreamio EMP-TW10 Guide De L'utilisateur

• If problems with projection do occur, but the indicators do not show any abnormal conditions, please refer to the section
p
below, "When the indicators provide no help".
• If a condition occurs which is not listed in this table, please consult your dealer or contact the nearest address provided in
the "International Warranty Conditions" in the "Safety Instructions/World-Wide Warranty Terms" guide.
• If you follow the above steps and are still unable to correct the problem, please cease using the projector, unplug the
projector from the electrical outlet and request repairs from your dealer or nearest address provided in the "International
Warranty Conditions" in the "Safety Instructions/World-Wide Warranty Terms" guide.

When the indicators provide no help

fNo images appear (Nothing is displayed)
fNo images appear (Messages are displayed)
"No Signal."
• Was the power turned off
and then straight back on
again?
• Has a Sleep Mode interval
(5, 10 or 30 minutes) been
set?
• Has the image brightness
been adjusted correctly?
• Is the projected image
completely black?
• Is an image signal being
input?
• Is the input source
properly selected?
• Are the cables connected
properly?
• Has external video output
been selected on the
computer?
You cannot begin projecting again for at least a minute
after projection has been stopped, even if you press the
[Power] button on the control panel or remote control.
Allow the projector to cool-down completely before
projecting again.
When a Sleep Mode interval has been set, the lamp cuts
out after no operations have been carried out for the set
time (5, 10 or 30 minutes).
The power indicator lights orange at this time.
Adjust the brightness in the following way.
[Menu] button → "Image" → "Picture Quality" →
"Brightness".
Some images being displayed, including some screen
savers, may be completely black.
Check if a picture signal is being input.
Set the "Message" option to "ON" in the "Setting" →
"On Screen Display" → "Message" configuration menu, in
order to view the picture signal information.
Press the [Source] button on the Control panel until the
correct input source is selected. For the remote control,
press the [Input A/B] button or the [S-Video/Video]
button.
Check that the cables are securely connected.
Depending on the equipment you are using, some settings
may need to be made on the video equipment. Refer to the
User's guide of your video equipment.
When using a laptop or a PC with an in-built monitor,
select external video output on the computer.
s "Laptop connection" P.10
When You Suspect a Problem-
Troubleshooting
17