Epson Dreamio EMP-TW10 Guide De L'utilisateur page 16

Configuration Menus
fSetting menu
Sub menu
Screen Position
Zoom
Caption
Keystone
Projection
Setup Level You can select one of two preset black levels.
Operation Sleep Mode Sets the energy saving option for when no signal is being input.
Child Lock Sets child lock to ON or OFF.
On Screen Message
Display
Background
Color
Startup
Screen
Input Video
Signal Signal
Input A
Volume
Language
Reset
14
-Function list
Moves the image display position vertically and horizontally.
• Press the [e] button and adjust the display area on the Position adjustment screen which
is displayed.
Adjustment is possible only when the Zoom aspect function has been selected.
• Vertical size : You can adjust the vertical size of the image.
• Zoom Position: You can adjust the vertical movement of the display position.
Corrects vertical keystone distortion in the image.
• The projected image changes when keystone correction is carried out.
• If the images become uneven in appearance after keystone correction has been carried
out, decrease the sharpness setting.
• Front : Image is displayed, as is. No vertical/horizontal reversal performed.
• Front/Ceiling: The image is displayed vertically reversed.
• Rear : The image is displayed horizontally reversed.
• Rear/Ceiling : The image is displayed vertically and horizontally reversed.
(When the image source is an NTSC Video/S-Video signal, or when the image source has
been set to Input A, "Component".)
• When a Sleep Mode interval has been set, the projector will enter Sleep Mode when no
operation has been carried out for the set time (5, 10 and 30 minutes). Projection will shut
down and the projector enters a standby state after cooling down. (The power indicator
lights orange).
• Projection starts again when the [Power] button is pressed on the projector's contol panel
or the remote control.
When child lock is set to "ON", the power will not come on unless you press and hold the
[Power] button on the control panel for at least 3 seconds. (The remote control functions as
normal.)
When set to "OFF", messages such as "No Signal.", and the name of the selected input
source or colour mode will no longer be displayed. Warning messages such as "Replace the
lamp" will continue to be displayed.
Sets the background colour to black or blue.
Sets whether or not the "EPSON" logo will be displayed during projector startup.
Selects the colour system of the video signal being input.
(Changes in signal format will only be noticeable when the input source is Video/S-Video.)
You can switch between the sources connected to Input A.
• Component: YCbCrg/YPbPrg
• RGB-Video: SCARTg, Sync on Green
Adjusts the volume setting
Selects the language in which on-screen messages are displayed.
• Press the [e] button and select the desired language from the list which is displayed.
Resets all the adjustment values within the "Setting" menu (except for "Child Lock",
"Input A" and "Language") to their default settings.
• Press the [e] button and select "Yes" on the confirmation screen which is displayed.
Function